That sensor is answered by a verified mechanic for honda.
Honda odyssey sliding door sensor location.
Clear the dtcs with the hds.
Rehome the affected door s and open and close the power sliding door six or seven times.
B2038 left power sliding door base position switch circuit open short and or b2088 right power sliding door base position switch circuit open short.
I ve pulled the switch and it is fine.
The likely reason is the sensor popped out and so the car thinks the.
It s labeled main press and hold both power sliding door buttons until the doors close completely.
To fix the problem seal the power sliding door rear pulley mount reposition the foam block dry connector c701 and apply dielectric grease to the connector.
Repair honda odyssey sliding door problem.
Refer to page 22 436 of the 2005 odyssey service manual or.
Honda has determined that the cause water entering connector c701 that s located behind the left rear side trim panel.
Turn the switch back to on the power sliding doors should be reset.
If this does not work turn the main switch to off and manually close the doors.