Honeywell Water Heater Pilot Will Not Light

It consists of the on off pilot dial as well as the thermostat dial.

Honeywell water heater pilot will not light.

If you don t see a spark at all when you are trying to light your pilot it may be that you are not looking in at the right angle. If the pilot doesn t relight if it goes out right after lighting or if the pilot light keeps going out by far the most common. Use my amazon link to shop. A faulty thermocouple or malfunction of the gas valve could be the culprit but the problem may be as simple as a draft coming from a crack in the wall or under the door.

The pilot is not lit air in the gas line the thermopile is not hot enough. Without it the water heater won t be able to maintain internal temperatures allowing the water to cool off. Although a blocked gas line is one reason why the pilot light on a rheem water heater won t light or stay lit there are other reasons as well some easier to correct than others. When i lit it manually this time the pilot was very week and i was thinking the thermopile was not getting hot enough low millivolts to operated the electronics.

It s free for you to use and amazon pays a small commission https amzn to 33i9exy in this vid. If the smell does not dissipate replace the heater s control valve before proceeding. The system kept coming back with 4 flashes. I ve replaced thermocouple before on my old water heater with manual type valve but the pilot would always light and when i released the button to adjust burner setting it would go out.

The air intake is located on the bottom or side of the water heater and may need to be cleaned out in order for the pilot to stay lit. If you smell gas do not attempt to light the heater. The water heater pilot light is a small flame that ignites the gas burner on your water heater. Remove the pilot light access cover.

There are several possible reasons why the status light may not be blinking. I first tried resetting the module by turning it to off and re start the pilot light by turning the dial to pilot holding down pilot and push the spark igniter. It is located near the bottom of the tank. Want to say thanks for the video.

Please read the safety information in the owner s manual and the labels on the water heater before attempting any of these procedures. The control valve is the box located by the access cover. Based on the status light code it means temperature exceeded. Pilot light issues are some of the most common problems experienced with gas water heaters.

Except when it s not working. You have to put your ear down to the floor to see the pilot.